Welcome To EzAuto Wrap
Cart 0
Welcome To EzAuto Wrap
Cart 0
6pcs 4"x6" 2D Carbon Fiber GMC Emblem Overlay
6pcs 4"x6" 2D Carbon Fiber GMC Emblem Overlay
6pcs 4"x6" 2D Carbon Fiber GMC Emblem Overlay
6pcs 4"x6" 2D Carbon Fiber GMC Emblem Overlay
6pcs 4"x6" 2D Carbon Fiber GMC Emblem Overlay
6pcs 4"x6" 2D Carbon Fiber GMC Emblem Overlay
6pcs 4"x6" 2D Carbon Fiber GMC Emblem Overlay
6pcs 4"x6" 2D Carbon Fiber GMC Emblem Overlay
6pcs 4"x6" 2D Carbon Fiber GMC Emblem Overlay
6pcs 4"x6" 2D Carbon Fiber GMC Emblem Overlay
EzAuto Wrap

6pcs 4"x6" 2D Carbon Fiber GMC Emblem Overlay

$8.98 $0.00

Description

-Fits the following GMC vehicles-

**This kit will not work with other GMC model years because the emblems will not allow the vinyl to adhere properly**

2007 GMC Sierra 1500 New Body Style

2008 - 2017 GMC Sierra 1500

2014 - 2017 GMC Sierra 1500 Front/ Rear

2007 - 2017 GMC Yukon

All Years GMC Terrain

All Years GMC Acadia

--Please Read Before Purchasing--

Included- (6) 6" by 4" Vinyl Sheets. (Not a precut letter) **Emblem not included** These are not precut because a vinyl sheet is easier to apply than a precut decal. A precut decal requires perfect alignment, while a sheet allows you trim off the excess vinyl. (Allowing more room for error).

Instructions are listed below for the install; it is highly recommended that you follow them.

Installation Instructions

-Recommended installation weather is to be above 50 degrees and not to be in direct sun light

-If you end up with small bubbles under the decal, they will dissipate in the heat after a couple days

**Important**- Use the following step if you are having issues getting the decal to stay stuck down in the corners of the emblem. It will also help if the decal is bunching up around the curves.
 - Lightly heat the decal with a hair dryer and carefully use the squeegee to force the decal into the corners of the emblem. For the curves, it helps to slide the wedge tool around the beveled edge with light pressure.

Specification:

  • Water resistant and weather proof.
  • Flexible and Stretchable for concave area.
  • Low cost to change the look of your vehicles.
  • Easy installation with dry application method.
  • Heat gun or household blow dryer for shaping is required.
  • Low - medium tack self adhesive .
  • Easy to fit in most tight spots or corners (3M primer 94 is required for non sticky surfaces, curves & corners)
  • Material has no warranty for fading. Fluorescent Neon colors tend to fade faster than normal colors. Fading can be reduced with over lamination, preventing stretched areas, which fade even faster, and shelter from high U.V. times during the day.
  • Material is specially made for vehicle exterior paint surface in good condition. Buyers take self responsibility on unsuccessful result on other usage.
  • Always pre-test vinyl installation on vehicles.
  • Due to different monitors/calibrations, colors may vary slightly from the pictures.
  • Film colors can vary slightly from roll to roll. For the most consistency, please purchase a full roll.
  • For best result, professional installation is required; Buyers take responsibility on physical damage during installation such as over heating, over stretching, ripping.

    • Share this Product