ESSMO™
Essmo™ Glow in the Dark Orange Heat Transfer Vinyl HTV GD03
Regular price
$8.99
Material Specification:
- PU Composition
- Thickness:221 Microns / 8.7 Mils (Please make sure plotter is capable of cutting such thickness)
- Heat pressure sensitive backing
- Glow in the Dark Design Finish
Application Instruction (Home Iron)
- Set iron dial between Cotton and Linen
- Cover design with Kraft paper or non-stick cover sheet
- Place on flat, hard surface (ironing board not recommended)
- Press iron with medium/firm pressure (do not slide iron)
- Press each section of design for 10-15 seconds
- If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds
- let it cool for about 30-45 seconds and then gently peel back the clear plastic until it is completely removed.
Application Instructions (Heat Press)
- Cut in reverse
- Weed excess material
- Preheat all fabric prior to pressing for best results
- Apply design at 305°F/150°C for 10-15 seconds
- let it cool for about 30-45 seconds and then gently peel back the clear plastic until it is completely removed.
Applies to:
- 100% Cotton
- Poly / Cotton Blends
- 100% Polyester
- Leather
Laundering:
- Wait 24 hours before 1st wash
- Machine wash warm or cold / mild detergent
- Dry on normal dryer setting
- Do not bleach or dry clean
Note: Material will be rolled for shipment. Due to the nature of the material, wrinkles might appear after unroll. In this case, peel off the transfer tape (clear film) and re-apply transfer tape onto the film with heavy flat item on top such as yellow page for 15 minutes, the film will be back to the flat shape.